在线等 英文翻译

2024-12-05 06:19:24
推荐回答(2个)
回答1:

Only when the SCR with a set work, and the SCR input current to 250A or so, AHF will work input, a, b, c three-phase voltage does not rise to 450V. If the SCR does not work, while the AHF to work on their own circuit board, replace the AHF. SCR can also work to AHF's hit the off switch to prevent AHF input, when checking a, b, c will increase the voltage. If the AHF does not put in the work of a, b, C voltage is also increased please check SCR working correctly. If the SCR work alone does not put AHF when a, b, c voltage is normal does not increase, while the AHF, after input a, b, c voltage is increased, please observe the COSΦ whether to show-off meeting, if it is too make up the work because SCR Output voltage high power factor high, oxidation current density is too large. The use of four devices have two appear a, b, c voltage increase. If the individual whether they will open up? ?

回答2:

Only when the SCR belt, and work in the input current reached around the SCR 250A and will only work, AHF a and b, c three-phase voltages will rise to 450V. If you don't work, while the SCR own work please replace AHF AHF PCB. Can also work in the AHF SCR switch to off, then don't let AHF check a, b and c will increase the voltage. If you don't work, AHF b and C voltage increased please check the SCR is functioning properly. If the SCR work alone is not a and b, when AHF c, while not voltage normal after a and b AHF voltage, c, please observe whether have Φ COS, if that is fill is at work because of high voltage SCR and power factor, excessive current density of oxidation. By use of four devices have two will appear a, b and c voltage rises. If you would open up alone?